How to repair a damaged leather bag

Leather is a material that can deteriorate over time, especially if it is not taken care of. If your leather bag is in bad condition and you take great care of it, here are some tips to fix it. You won’t need to forget it in the back of the closet. Now your accessory can be worn on the shoulder or held proudly in your hands.

Having done the necessary, it is quite possible to give the handbag a second life. Here are proven tricks to fix it.

How to repair a damaged leather bag?

Before starting repairs, you must Thoroughly clean your leather bag. This allows you to see exactly part to be repaired and from bring the skin into good condition to be able to apply them necessary procedures.

Detachment of the skin on the surface is worse and cannot be effectively repaired. However, even the highest quality leather handbags can be chipped on the straps or in high stress areas. This is due to the fact that the coating was damaged.

Repair of chips on the edges, corners and edges of the bag

Areas that are used very often are the most vulnerable and end up flaking off faster. You can fix them with reducing dye for the skin. You can also use this method to repair deep scratches on colored leather.

What you need:

Leather dye in the same color as your bag
small brush

After cleaning the bag, apply a thin layer of leather dye with a brush to the damaged area and allow it to dry.

Several layers will need to be applied to the edges of the strap. Sometimes it may take up to 5 or 6. Let each coat dry before applying the next.

In the case of deep cracks in the skin, the second tip is to seal them. Here’s how:

Repair deep cracks and fill in the scales of the handbag

If your leather is fragile and starts to wear, it may have deep cracks or tears, especially around the piping, reeds, and edges. Here’s what you need to do to fix it.

What you need:

skin cleaner
Cloth or sponge
Super fine sandpaper 600 grit
Skin repair paste
Palette knife

Apply a leather cleaner to a cloth or sponge and clean the bag (test on a small area first before applying to the entire bag).

Let the skin dry completely: If there is moisture on the skin, this will prevent the sealant from hardening in the cracks. Wipe off any moisture with a dry cloth to speed up drying. Then sand the cracks with sandpaper.
Apply the product in a thin layer: smoothing by hand or with a palette knife, then remove excess dough.
Let the skin dry for several hours:This step ensures that the putty sets and hardens. A well-ventilated area or open air will allow the skin to dry faster. However, avoid exposure to sunlight or heat, as these can dry out the material and cause new cracks.